I've used slinkys in the past (and still do now and then) and still think a bright section of mono tied into the leader works better. What I've also found is, the little football indicators, like Fish Pimps, work just as well. I'll pull the rubber out and thread the tippet/leader through the tubing. Place the indie at the desired location on the leader and have at it. If you use the smallest size football indie, it will be almost as sensitive as a slinky. Plus, using the smallest size, you can suspend it an inch or 2 over the water and watch for it to stop or twitch, without creating any drag. It also keeps you in direct contact with the flies. I also like it because it gives you an exact location of where your line is going into the water at all times. I've caught lots of fish by casting upstream, letting the flies drift back to me, then letting them go past me downstream and lifting the indie off the water at the same time to create a kind of pendulum effect with the flies swinging through the water column. It works even better during hatches when you can put on a nymph or 2 and an emerger. It is also nice to use the footballs when the fish aren't active, because it will let you move the nymph faster or slower through certain areas. I've ran into situations where the fish would only take nymphs stripped a little faster than what the water was flowing. The football helps to show where the nymphs are and how fast they are moving through the water. The only situation it doesn't work well in is super fast water. In that case, I over weight the tippet and try to get the hinged leader effect, if using an idie. Without an indie on I over weight and use the bright section of mono. I will also only use white and black indies, unless the conditions make them hard to see. In that case I add a bright section of mono, or use 2-3 small sections, approx. 1" long, of bright colored rubber tubing several feet up my leader. With three flies and splitshot on, the rubber tubing will not cause any drag if fished properly. All you have to watch for is the tubing to stop or twitch at any point through the drift, and then set the hook.
I've also found using a Sharpie to add stripes to the curly indies makes them easier to see, and might even cut down on the chances of it spooking a fish.