Rod Section Replacement Question

Also, with tip-over joints you don't have to worry about the ferrules fitting to a specific size.. it jsut keep slidin' down til it fits on the next piece.

To an extant yes, but.....

If the male ferrule has a slightly steeper taper than the female ferrule, you'll never have a good fit and likely split the female ferrule in effort to jam the male end in tighter.

Fwiw, this is also why ferrule tightness should be checked during the course of the day as temperature changes. Loose ferrules will wear down. Particularly the male side and there's not a whole lot you can do to fix it.
 
I think this is the case with tip-over-butt and sleeve-over where the female & male ferrule tapers are part of the mandrel, but spigots on better rods are still fitted.
Yes that NFC rod has tip over frerrules.

Do you know of any graphite rods that still have spigots? Scott G?
 
Yes that NFC rod has tip over frerrules.

Do you know of any graphite rods that still have spigots? Scott G?

Lots of custom & boutique options use them and I believe Winston is still offering spigots on some rods.

In all honestly, I came kicking and screaming to spigots because I hated the look. However, today with the exception of my old graphite Orvis Limestone Special...

All of my graphite trout rods and all but one glass trout rod has spigots.
 
thing is, of the 4 rods I sent back, none were for a damaged tip section
I have had the same experience. One butt section broke, one second section broke, and one tip section over many years of fly fishing. Two of the 3 ( butt and 2nd section) were replaced for no charge by G. Loomis. Did have to pay warranty for the broke tip section
 
Back
Top