Fly of the Month: Ryguyfi’s Cotton Candy Egg FlyPublished by Ryan Gouldsbarry [ryguyfi] on 10/18/2010 (4053 reads)
I write to you today as an addict, and as I quote flipnfly, “one who doesn’t want an intervention”. Here below is my recipe for a simple single yarn egg pattern. When the steelhead are in full spawn, it is hard for them to turn down a good looking egg. Yet in my experience I have added a few steps to make this fly more durable. During a good steelhead run, the thrill is also landing one fish quickly so you can get onto the next. It can be non-stop action, so having to tie on another fly because yours has been destroyed, or torn off the hook may cost you your next fish. I hope that my experience and slight changes may bring you more fish to hand.
More after the break Ryguyfi’s Cotton Candy Egg Fly
Sz 10 dai riki scud hook (I use sizes 10-18 typically, but love a big egg)
210 denier white thread
Blue egg yarn
Pink egg yarn
The first step is to wrap the entire length of the hook with thread and stop directly above the point of the hook. Proceed by putting a layer of finishing cement over all of this thread. Wait untill it dries before moving on. I found that I was having my eggs slide around on my hook and eventually falling off. This made them more secure.
Next is to tie on your blue egg yarn. (any color combination will do) The trick with all egg patterns like this, is to add as much tension as possible to get the egg to splay outward and get that round egg look. This is why I use 210 thread, so I can get the added pressure needed for a good egg. I usually use 2 wraps of thread for each layer. Too many wraps gives it too much thread bulk.
After this I put a small amount of pink yarn in. When finished, this will produce the “blood dot” that is pretty typical of trout and salmon eggs.
My next 2 steps are to double the blue yarn over the top of the pink so as to cover it up completely.
This next step is also to help make the fly more durable. I pull the yarn up as shown with my fingers and wrap the thread 3-4 times around the base of the yarn, by the hook, kind of like a parachute. This make sure the yarn is secure in that exact spot and also helps against the slippage. I then advance the thread to the eye, whip finish and cement.
The next step is impossible to photograph, because it needs both hands. I pinch my yarn, as in the picture above, and simply take some sharp scissors and give it a hair cut. My advice is to pinch tight, this will give you the look that you want. You can trim it a bit here and there, but if done right it will look like an egg with one cut.
Here is the finished product, with the visable blood dot in the 2nd picture.
Ryan resides just north of Pittsburgh in Beaver county with his wife and newborn daughter. When he's not on paflyfish.com or on the stream he works as a Financial Services Representative at a large insurance company doing a wide array of things from insurance sales, to financial and retirement planning. Feel free to contact him for help in any these areas.
|Navigate through the items|
|Fly of the Month: David Weaver's "Scud"|
The comments are owned by the author. We aren't responsible for their content.