Browsing this Thread: 1 Anonymous Users
From Bucks County
Next FF newbie question:
Do I understand correctly: We use a pre-made tapered leader with, say, a 5X tippet (0.006" dia, 4.4# test)and then tie an additional length of straight tippet material (in this example, 5X or lighter)to that?
I'm assuming this is done to conserve the original, tapered leader/tippet; not that it's a required addition to a "finished" leader/tippet. Is that correct?
Posted on: 12/8 17:21
Re: Leader/tippet ?
From Chester County
Most knotless tapered leaders are tapered properly as is. It may be possible to add a short tippet (12 - 24"") of the same diameter (5x in this case) or one size lighter (6x). If you have trouble turning over your fly, cut the leader back a bit before tying on your tippet, or fish with a new leader without adding tippet, and add it only after it has been shortened by 12-24".
You may have to play with your leaders a bit to see what works best for the tippet diameter and the size and type of flies you are fishing.
A general rule of thumb for tippet / fly size is: Fly size divided by 4 and add 1.
Size 12 fly / 4 = 3 +1 (4x tippet)
Size 16 fly / 4 = 4 +1 (5x tippet)
Size 20 fly / 4 = 5 +1 (6x tippet)
Another general rule is shorter and/or heavier leaders make it easier to turn over your flies.
Posted on: 12/9 7:10
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.